Recoil springs for Colt Commander series pistols are available in both conventional and variable power designs. Please refer to our FAQ section for information on conventional vs. variable design. Each recoil spring for Colt pistols includes an extra power firing pin spring.  Recoil Calibration Paks are available offering a range of spring weights to tune your pistols recoil function.

Super .38/9mm Note:
The factory recoil spring rating for the Commander Super .38 & 9mm calibers is 16 pounds. When ordering above recoil springs for these calibers, please take this difference into consideration.

---

CONVENTIONAL RECOIL SPRINGS - .45 ACP

   Reduced Power...: 12, 13, 14, 15, 16, & 17 Lb.
   Factory Standard.: 18 Lb.
   Extra Power........: 20, 22, 24, 26, & 27 Lb.

   Reduced Power...:  7, 8, 9, 10, 11, 12, 13, 14, 15, 16, & 17 Lb.
   Factory Standard.: 18 Lb.
   Extra Power........: 19, 20, & 21 Lb.

Recoil calibration paks are offered to allow the shooter a choice of recoil springs to calibrate the recoil function when the correct spring rating is not known. These paks offer a savings of 20% over the same purchase of individual springs. The shooter starts with the strongest spring in the pak and works down until the desired recoil function is obtained.

Reduced Power Pak - Conventional
This pak contains 1 each of 12, 13, 14, 15 & 16 Lb. reduced power conventional recoil springs and 3 each extra power firing pin springs. Order Stock No. 13102 below

---

Extra Power Pak - Conventional
This pak contains 1 each of 18 Lb. factory standard spring, 20, 22 , 24 & 26 Lb. extra power conventional recoil springs and 3 each extra power firing pin springs. Order Stock No. 13101 below

---

Reduced Power Pak - Variable
This pak contains 1 each of 18 Lb. factory standard spring, 10, 11, 12, 13, 14, 15, 16 & 17 Lb. reduced power variable recoil springs and 3 each extra power firing pin springs.Order Stock No. 13105 below

For use in:
Colt Commander series pistols. Please Select appropriate caliber.

Type I - contains the following factory specification springs: recoil spring, firing pin spring (extra power), hammer spring, magazine catch spring, plunger tube spring, firing pin safety spring and sear spring.

Type II - contains all of the springs described in the Type I pak above and a 10 pound extra power magazine spring.

For all other Commander springs (firing pin springs, firing pin safety springs, hammer spring, magazine catch springs, plunger tube springs, and sear springs) please view the Colt 1911 products by clicking here. The Colt Commander uses the same internal springs as the 1911 for these applications.